Check the operation status of the machine and prepare a thorough inspection program has become increasingly serious. Among them TIMKEN bearings focus attention, because it is the most important of all rotating machine parts. Condition monitoring is an important part in preventive maintenance. Early detection of bearing damage in order to avoid equipment downtime due to the tapered roller bearing damage caused by unplanned maintenance period.

However, not all of this and are equipped with advanced instruments. In this case, the machine operator or maintenance engineer must TIMKEN bearing the "fault signal" remain vigilant, such as noise, temperature and vibration. "Listen" "Touch" and "watch" four important factor.

First, to keep clean TIMKEN bearing and its surroundings

I do not know how else to say it, even invisible dust into the bearing, but also make tapered roller bearing wear, put it plainly, not rub eyes slightest sand, is a reason!

Second, the use of installation should carefully accurate installation

It will not even so little common sense would not it, if not, then do not make tapered roller bearings, and go home to play, the most important thing is not allowed powerful punch, does not allow a direct hit with a hammer bearing, not afraid smashed, smashing the deformation give you, how do themselves bear the loss of it, ha ha, there is pressure not allowed to pass through the body.

Third, the use of appropriate, accurate installation tool

Try to use a special tool, try to avoid using fabric and staple fiber stuff like that.

Fourth, to prevent corrosion of bearings TIMKEN, not with blisters

The bearings are made of steel, but also afraid of the water, if you do not believe, you put water clubbing, huh, hand pick tapered roller bearings, to fully wash hands sweat, and coated with high-quality mineral oils after before proceeding, during the rainy season and summer with particular attention to rust, do not tell me what to say rusty afraid, well, you try it and see what the outcome will rust!